Right Staircase from floor1 to floor 2

Previous item Next display Floor down Floor up All the way back

Acoustic Modems [Gio] (1968)

left side

In 1955 the modulator/demodulator (modem) was invented, allowing use of audio telephone lines for data communication. By 1956 one was permitted to transmit non-spoken sounds over telephone lines for simple image scan transmission. Starting in 1958, telephone company did provide what they called a `dataset', that could be leased for about $40/month and would have to be installed by them. In 1961 the standard for using touch-tones, also using audio instead of sequences of line interruptions (10/second) for dialing, was released.

Up to 1969 FCC regulations, instigated by the telephone companies, did not allow customers to directly connect equipment not provided by the telephone company to their lines. The court case for gaining access for connecting radio-telephones (the 1968 Carterphone Decision) had been filed by Thomas Carter of Carter Electronics of Dallas first in 1958 and refiled in 1966. It still required protective interface devices. It took to 1978 to allow direct connection to RS-11 and similar plugs and get all the new tariffs in place.

To avoid this cost and hassle Accoustic Modems or Couplers were developed around 1966, a.o.. by John Van Geen at Stanford Research Institute, that mimicked handset operations. One would dial the computer system (which would have telephone company datasets) on one's phone, and when the connection was established, place the handset into the accoustic modem. Since the handsets were all supplied by the telephone company, most had the same shape, simplifying the physical Interface.
A microphone and a speaker inside the modem box would pick up and transmit the signalling tones, and circuitry would convert those audio shift-key encoded frequency binary signals for an RS232 output socket. With luck one could get 300 baud (~bits/second) transmission rates, but 150 baud was more typical. That speed was sufficient for typewriter-based terminals, as the IBM 2741, running at 147.5baud, or a teletype, running at 110baud.
The model shown was built by Livermore Data Systems. Andersen Jacobson became a major supplier.

Stanford SAIL-built 1200/150 baud Modem, 1974 [Gio]

( above: Selecterm 300 baud Accoustic Modem [CMHC] )

Courtesy Gio Wiederhold

After the Carterphone decision customers were allowed to non-telephone Company equipment directly to telephone lines. Commercial modems of 300 and 600 baud duplex capability became available, but were frustratingly slow for display users. Students at the Stanford AI lab developed and built a number of asymmetric modems: 1200 baud from computer to terminal and 150 baud from keyboard to the SAIL computer. The design was copied in other academic sites, but was obsoleted when 1200 baud full-duplex modems became available at less than $1000 in 1976.

The direct-Coupled Asymmetric Data Modem shown has 150 send / 1200 baud receive capability. It was designed by Kok Chen of the Radar astronomy group of Prof. Allen M. Peterson in 1974. Kok Chen was also active among the LOTS group (Ralph Gorin, Len Bosack (later a founder of CISCO), et al.).
When most CS AI graduate students lost their office space during the move from the D.C. Powers Lab (in the background) to Margaret Jacks Hall on Campus, Kok Chen released his homemade 1200/150 modem design to the guys at the CS department so that the displaced students could at least view data at 1200 baud instead of 300. A couple of hundred boards may have been built.
floor3 right front and rear

Previous item Next display Floor down Floor up All the way back